150mm Concrete Cube Moulds for Testing Strength

Description

About the Product 🔑

• Plastic Concrete Cube Molds, 150x150mm are one-piece units used to mold consistent concrete compressive strength specimens for strength testing and set-time determinations following ASTM C403/403M, AASHTO T 197/197M, and EN 12390-1 standards.
• Single-cavity plastic cube mold. Used for compression testing of concrete cubes and for mortar specimens in the time of initial and final setting of concrete. 150 x 150 x 150mm
• The 150mm Concrete Cube Mould, High Density Plastic is a mold used in concrete testing to cast standardized cube specimens measuring 150mm on each side. Crafted from durable high-density plastic, this mould offers exceptional resilience against wear and tear, ensuring long-term reliability in testing procedures.

Usage Instruction 🛠️

• Fill the moulds with concrete in 50mm layers. Tamp each layer at least 45 times with the tamping rod to get the air bubbles out. the last layer should more than fill the mould. After tamping the last layer, trowel the top of the concrete so that it is level with the top of the mould. Write the following on a label for each :- the Contract …

Concrete test mould cube made from a rigid steel construction. four parts with a abse plate – …

Product Specification 📱

• Size: 150x150mm 📏
• Material: High Density Plastic 🧱
• Type: Single-cavity 1️⃣
• Standards: ASTM C403/403M, AASHTO T 197/197M, EN 12390-1 ✅
• Use: Compression testing of concrete cubes and mortar specimens 🔬

Product Details 🏷️

• Cube Mold Testing in Concrete measures the compressive strength of concrete by applying a controlled load to a hardened cube specimen. Engineers use this method to verify whether the concrete meets the required grade and design strength. Therefore, this test plays a key role in QA/QC at construction sites and testing laboratories.
• Why Do We Cast Cubes? Cube Strength = Strength of Concrete Strength of Concrete = Strength of Structure Cube Moulds Standard Cube Mould size – 150mm * 150mm * 150mm Cube moulds should be non absorbent, non reactive and metal moulds to be used (Cast iron). Two piece cube are recommended. with extended base plates are mandatory requirement. Tamping rod shall be 16±0.5 mm …